Thread for Headlight screws
3 posters
Page 1 of 1
Thread for Headlight screws
siobhanellis Fri Feb 14, 2014 7:43 pm
Hi everyone,
I had to drill out one of the holes for the headlight screws, and so now need to tap it. Anyone know what tap I need including pitch?
Siobhan
I had to drill out one of the holes for the headlight screws, and so now need to tap it. Anyone know what tap I need including pitch?
Siobhan
siobhanellis- Posts : 149
Join date : 2010-06-28
Age : 60
Location : Sydney, NSW, Australia -
Re: Thread for Headlight screws
Thackers Sat Feb 15, 2014 5:49 am
I think the original would be around m3 or m4 probs the same as a G.P.
Thackers- Posts : 831
Join date : 2010-06-26
Age : 61
Location : No 20 on Moonage Daydream Harrogate n.yorks
Re: Thread for Headlight screws
siobhanellis Sat Feb 15, 2014 1:32 pm
Thanks.
I know it isn't an M3 as a 3mm drill fits in the hole. I've since found out it is coarse, but still don't know the size :-(
I know it isn't an M3 as a 3mm drill fits in the hole. I've since found out it is coarse, but still don't know the size :-(
siobhanellis- Posts : 149
Join date : 2010-06-28
Age : 60
Location : Sydney, NSW, Australia -
Re: Thread for Headlight screws
Snails Sun Feb 16, 2014 4:10 am
Gosh. Didn't even realise they were screws as mine was bolted on!
Snails- Posts : 968
Join date : 2010-06-28
Age : 53
Location : Luna Base Alpha
Re: Thread for Headlight screws
siobhanellis Thu Feb 20, 2014 7:46 pm
Well the answer is, it's an M4 with a 0.7 pitch.
siobhanellis- Posts : 149
Join date : 2010-06-28
Age : 60
Location : Sydney, NSW, Australia -
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum|
|
|